Label Machine (Interrupted)

The Labeling Device Interrupt dialog offers the operator buttons to interrupt the Auto Processor's Loading and Labeling Device.  The dialog can be accessed by clicking the label button in THM when the labeling device is busy or through the THM menu Control Options -> Label Options -> Label Machine.  The dialog will only interrupt the operation once it's task is complete and an option from the dialog is pressed.  If the labeling device is not busy the Label Machine  dialog will open which does not have the Continue option.

 

 

NOTE:  All the operations occur once the Labeling Device has completed it's current task.

 

Go Home -  Sends the Labeling Device to the home position.  If the home routine has not been ran it will perform a home routine.

 

Lower Stack - Lowers the lift table all the way down.

 

Raise Stack - Moves the Labeling Device to the center of the material.  Raises the lift until the sensor on the Labeling Device sees the stack is at the proper height for labeling.  If the device has not been homed, the homing routine will be ran first.

 

Position Sheet -  Homes the device if the home routine has not been ran since the device has been accessed by a program or this dialog.  Raises the stack if necessary.  Performs the positioning routine for the top sheet on the stack.  This is the position for labeling.

 

Stage Sheet -  Homes the device if the home routine has not been ran since the device has been accessed by a program or this dialog.  Raises the stack if necessary.  Positions the sheet if necessary.  Stages the sheet so that the router may load it onto the table.

 

Label Starting With... - Opens a dialog for entering which part to begin or start over labeling.  Each subsequent part will be labeled.

 

Continue - Closes the dialog and allows the Labeling Device to continue normal operation.

 

Abort - Cancels the labeling procedure for this sheet and sends the Labeling Device back to Home.