Label Machine

The Labeling Machine dialog offers the operator buttons to manually operate the Auto Processor's Loading and Labeling Device (Label Machine).  The dialog can be accessed by clicking the label button in THM when the labeling device is NOT busy or through the THM menu Control Options -> Label Options -> Label Machine  If the labeling device IS busy the Label Machine (Interrupted) dialog will open.

NOTE:  Raise Stack, Position Sheet, & Label Starting With... options will not be enabled if a labeling job is not loaded in THM.

Go Home -  Sends the Labeling Device to the home position.  If the home routine has not been ran it will perform a home routine.

Lower Stack - Lowers the lift table all the way down.

Raise Stack - Moves the Labeling Device to the center of the material.  Raises the lift until the sensor on the Labeling Device sees the stack is at the proper height for labeling.  If the device has not been homed, the homing routine will be ran first.

Position Sheet -  Homes the device if the home routine has not been ran since the dialog has been started.  Raises the stack if necessary.  Performs the positioning routine for the top sheet on the stack.  This is the position for labeling.

Stage Sheet -  Homes the device if the home routine has not been ran since the dialog has been started. Raises the stack if necessary.  Positions the sheet if necessary.  Stages the sheet so that the router may load it onto the table.

Label Starting With... - Opens a dialog for entering which part to begin labeling.  Each subsequent part will be labeled.

Close- Closes the dialog.